Skip to content
Croydon ConcretingCity of Maroondah

Croydon and the City of Maroondah

Concrete removal and replacement in Croydon

Old driveways, paths, slabs and paving broken out, loaded and disposed of across Croydon and the City of Maroondah, and the new surface poured on a corrected base. Removal adds $35 per m2 to the rate for whatever replaces it.

Concreters spreading wet concrete over steel mesh
Concreters spreading wet concrete over steel mesh
Recent work
Site measure Free, at your place
Quote Fixed, in writing
Steel In every slab
Area City of Maroondah only

$130 to $220 per m², supplied and laid. Prices may vary with site conditions and variations.

Half the concreting in the outer east is replacement, because the suburbs were built out decades ago and the original surfaces are at the end of their lives. Cracked driveways that drop at the crossover, paths lifted by tree roots, shed slabs that were never thick enough: they all come out the same way, and what matters is what happens before the new concrete goes down.

The break out

The old surface is broken out, loaded and carted for disposal, including the mesh or reo in it if the original crew used any. Edges against buildings and fences are cut clean rather than crashed through, and services under the old slab are located before anyone swings a breaker.

The part that stops it happening again

A failed slab is a message about the ground under it. Replacement is the one chance to answer it: soft spots dug out, base material brought in and compacted where the ground needs it, falls corrected so water stops pooling, and steel mesh in the new slab as standard. The specification sets out exactly what goes under every surface we pour.

What it costs

Removal adds $35 per square metre, including disposal, to the rate for whatever replaces it: a replaced driveway runs $130 to $220 per square metre all-in by finish, a replaced path $125 to $165. Prices may vary with site conditions and variations; the written quote after a site measure is fixed. The cost guide breaks the numbers down and the calculator prices your job with removal switched on.

Concreters spreading wet concrete over steel mesh
The new surface going down
Steel reinforcement mesh tied before a concrete pour
Steel in every replacement slab

Where we pour concrete removal and replacement

Croydon, Croydon Hills, Croydon North, Croydon South, Heathmont, Ringwood and nowhere else: one council, known inside out.

Your job, start to finish

What happens when you call

  1. 01

    Site measure

    Free, at your place. The job is measured, falls and access are checked, and finishes are picked from sample boards against the house in daylight.

  2. 02

    One written quote

    One fixed number in writing, itemised against the published specification. If a council crossover permit may be required, you know before anything is booked.

  3. 03

    The build

    The old surface out where there is one, base material brought in and compacted where the ground needs it, steel mesh laid, then the pour. Most residential jobs are one to two days on site.

  4. 04

    The finish

    Control joints cut to direct any movement, exposed aggregate washed and sealed after cure, and vehicles on it seven days after the pour.

Common questions

Concrete removal and replacement questions

What does concrete removal cost?

As part of a replacement job, removal adds $35 per square metre to the new surface's rate, including breaking out, loading and disposal. A replaced driveway therefore runs $130 to $220 per square metre all-in by finish. Prices may vary with site conditions and variations; the written quote after a site measure is fixed.

Why did my old concrete fail?

Around Croydon it is nearly always the ground, not the concrete. The clay of the foothills swells through winter and shrinks over summer, and slabs poured decades ago with little base preparation and no steel follow that movement until they crack and drop. The fix is a corrected, compacted base and steel mesh, which is what every replacement gets.

Can you remove concrete without replacing it?

Replacement is our work; straight demolition with nothing poured after it is generally better priced by a demolition contractor. Where we pour the new surface, the removal is folded into the one quote and the one clean-up.

How long does a replacement take?

Most residential replacements are one to two days on site, break out and cart away, correct and compact the base, then pour. Cure time runs after that, with vehicles off a new driveway for seven days.

One fixed written quote after a free site measure.

Call (03) 7500 5497 Get a quote